Non Fused Disconnect Clearance

So the only two places for non fused disconnects are on systems with less than 5ka available fault current or on circuits already protected by appropriately sized fuses.

Non fused disconnect clearance.

The halex 60 amp 240 volt non fuse metallic ac the halex 60 amp 240 volt non fuse metallic ac disconnect is designed to stop the power going to an air conditioning unit to allow for safe working conditions. 110 26 of the national electrical code nec. You re not if you fail to comply with the following three clearance requirements in sec. A non fused disconnect generally has a short circuit withstand of 5000a and a fused disconnect very often has the withstand rating of the fuse that is inserted and approved by the manufacturer resulting in almost always 200k.

This means a 30 by 36 inch space or larger in front of panels access panels on hvac equipment and fused disconnects. The disconnect is a non fuse puller type and is ul listed with an enclosed pull out switch. 1 at least a 3 ft clearance in front of all electrical equipment. When dangerous fluctuations or interruptions are detected your disconnect will as you may expect disconnect power to the tool shutting off access safely before permanent harm or danger can arise.

There are fused and non fused non fusible. Nec 110 26 requires working clearance in front of equipment likely to require calibration testing or adjustment while energized. And 3 minimum headroom. A 3000a service entrance fuse won t protect the non fused disconnect it needs to a fuse of a size that would go in the disconnect if it were fused.

Does this requirement extend to non. 2 a 30 in wide working space in front of equipment operating at 600v or less.